DIRECTIONS FOR USE

• Turn off the device and remove the battery.
• Peel off the paper seal from the back of the Battery Extender and stick
  the Battery Extender to the battery case at the battery position, so that
  the metallic surface of the Battery Extender is facing the battery.
• Replace the battery and turn on the device. Charge and use as normal
  with Battery Extender attached.

If the Battery Extender patch is too large, you may trim it to fit the battery before removing the paper seal. It should cover at least 80% of one side of the battery surface.

Caution: Do not apply the Battery Extender patch across any of the metal battery contacts of the device applied to.

WARNING: This product is not for consumption.

Hints: The paper seal on the back of Battery Extender consists of two pieces. It is possible to remove only the smaller part of the seal to attach Battery Extender to your device, this makes it easier to remove Battery Extender in the future and/or put it onto another device.

Do not touch or try to clean the metallic surface of Battery Extender, this will impair it’s effectiveness.

The effect of Battery Extender may take 5 to 10 charging cycles before its full effect is noticed. Its recovery effect on older batteries can be quite dramatic whilst helping new batteries to maintain their power capacity.

Method – Remove the Battery and stick Battery Extender to the phone avoiding the metal contacts then replace the battery on top of Battery Extender and replace the battery cover.